 |
 |
 |
|
REMS Curvo Electric Pipe Bender Set, 580024. Wrinkle-free bends for pipes 10 - 40 mm, 1/4 - 1-3/8 inch, to 180°.
- Universal for many pipes and tubes
- Compact, with integral absorption of torque during bending (US-Patent 5,056,347)
- Super light, drive unit only 8 kg (17.6 lbs)
- Can be used anywhere without previous setting
- Fast and slow speed operation for precise bending. 90° bends, 7/8" diameter in only 6 seconds
- Former is has angle scale from 0 to 180 degrees
- Rapid change of bending and back formers
- Only one type of bending and back formers for REMS Curvo, REMS Curvo 50 and REMS Akku-Curvo
- Maintenance-free gear with safety slipping clutch
- Universal motor 110 V, 50-60 Hz, 1000 W (1.36 HP)
- Recover full cost of this tool after a small number of bends through savings on fittings
- Use with pipes diameter 10 - 40 mm (3/8 - 1-3/8 inch), up to 180°.
- Hard, half-hard and soft tubes, and thin-walled, diam. 10 - 35 mm, (3/8 - 1-3/8 inch)
- Coated soft copper tubes, also thin-walled, diam. 10 - 18 mm
- Stainless steel tubes of pressfitting systems diameter 12 - 28 mm (3/8 - 1-1/8 inch)
- Coated steel tubes of pressfitting system mapress C-STAHL diameter 12 - 28 mm
- Soft precision steel tubes diameter 10 - 30 mm, steel pipes 1/4 - 3/4 inch
- Conduit DIN EN 50086 diam. 16 - 32 mm
- Composite tubes diameter 14 - 40 mm, and others
- Includes drive unit, insert bolt, bending formers and back formers
- Set includes: 3/8", 1/2", 5/8", 3/4", 7/8" OD size formers
- Comes in sturdy steel case
- Made in Germany
|
|
|
 |
|
 |
|